CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 24)

Agent

 Make sure a USB or serial cable is connected between the Agent computer and the UPS. If Agent is installed on a

vMA running on an ESX/ESXi host, refer to FAQ chapter for further details how to add USB connection. If Agent is

installed on a vMA running on ESX/ESXi 5.x, refer to FAQ chapter to upgrade virtual hardware in order to add the

USB device of target UPS.

 NCL (Non-Critical Load) outlets on specific models are designed to shut off under certain circumstances to save

battery power and maximize the runtime on the remaining outlets. The Agent computer should not be connected

to NCL outlets. Refer to PPBE Installation Guide for UPS without RMCARD for detailed information about how

to plug the Agent computer into the correct outlets.

 Configure the Necessary shutdown time option properly on the Event Action/Settings page based off of how long

it takes for that computer to turn off completely after a shutdown has been initiated.

 Perform a battery test to verify the UPS can supply battery power to the connected equipment and the equipment

operates properly. See the UPS/Diagnostics section for more details.

Client

 Setup the SNMP community the same as in the remote management card of the UPS/PDU/ATS, or the Secret

Phrase used by the Agent on the Security/Authentication page.

 Set the port used by Client on the Security/Network page to match the port used by the Agent’s port.

 Assign the network address of the remote management card of the UPS, PDU or Agent, and assigning the

connected outlet on the Power/Configuration page.

 Configure the Necessary shutdown time option on the Event Action/Settings page based off of how long it takes

for that computer to turn off completely after a shutdown has been initiated.

Center

 In order to establish communication with the UPS, PDU, Agent or Client. Set the SNMP Community to the same

one used in the UPS/PDU/ATS, or the Secret Phrase used by the remote card of UPS, PDU, Agent or Client on

the Security/Authentication page.

 Setup that the port used by the Center on the Security/Network page to match the port used by the Agent or

Client.

Using PowerPanel Business Edition Agent and Client

System

Summary

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 132 133

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 24