CyberPower RMCARD302 Guide d'installation télécharger pdf (Page 1)

QUICK INSTALLATION GUIDE

Remote Management Card

RMCARD302

ntelligent Remote Management Card allows a UPS

system to be managed, monitored, and configured

K09-0000057-01

INSTALLATION GUIDE

5. Connect the Ethernet cable

to the LAN port of the

CyberPower Remote

Management Card.

6. Turn on the UPS.

4. Re-install and tighten the

retaining screws.

3. Install the CyberPower Remote

Management Card into the

expansion port.

2. Remove the two retaining

screws of the expansion port

cover then remove the cover.

1. Turn off the UPS before

removing the expansion port

cover on the UPS.

Definitions for LED Indicators

Step 2. Configure the IP address for the CyberPower

Remote Management Card.

Method 1: Using the Power Device Network Utility Tool

1. Install the Power Device Network Utility Tool from the included CD. It

is located on the CD in the \tools\nework folder. Double click the

“Power Device Network Utility” installation file, “Setup.msi” to begin

the installation.

2. After installation is completed, run the “Power Device Network Utility”

program. (Under “All Programs”, select “CyberPower Power Device

Network Utility”).

3. The main dialog of the Power Device Network Utility Tool program is

shown in Figure 1. The tool will display all Remote Management

Cards present on the network. The "Refresh" button is used to search

the entire local network again.

4. Select the Remote Management Card you are setting up. Click on the

Tools menu and select “Device Setup” or double click the Remote

Management Card you want to configure.

5. You can modify the IP Address,

Subnet Mask, and Gateway

address for the Device MAC

Address listed in the Device

Network Settings window, as

shown in figure 2. The default IP

Address is 192.168.20.177 and

the default Subnet Mask is

255.255.255.0.

Link LED color

Off

On(Yellow)

TX/RX LED color

Off

On(Green)

Flash

Condition

The Remote Management Card is not

connected to the Network or the Remote

Management Card power is OFF

The Remote Management Card is connected

to the Network

The Remote Management Card power is OFF

The Remote Management Card power is ON

- Receiving/transmitting data packet

- Reset finished

LINK Indicator

Ethernet connector

RX/TX Indicator

Step 1. Hardware Installation

Figure 1. The main window of the “Power Device Network Utility” program.

Figure 2. The Device Network setting window.

1 2

Résumé du contenu

Page 1 - RMCARD302

QUICK INSTALLATION GUIDERemote Management CardRMCARD302 Intelligent Remote Management Card allows a UPS system to be managed, monitored, and configur

Page 2 - Conformance Approvals

Method 2: Using a command prompt1. Obtain the MAC address from the label on the Remote Management Card. Each Management Card has a unique MAC address.

Commentaires sur ces manuels

Pas de commentaire

CyberPower RMCARD302 Guide d'installation Page 1

Naviguer en ligne ou télécharger Guide d'installation pour Contrôleurs de puissance à distance CyberPower RMCARD302. CyberPower RMCARD302 remote power controller Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

CyberPower RMCARD302 Guide d'installation Page 1

Naviguer en ligne ou télécharger Guide d'installation pour Contrôleurs de puissance à distance CyberPower RMCARD302. CyberPower RMCARD302 remote power controller Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de puissance à distance CyberPower RMCARD302