CyberPower PDU15SW8RNET Manuel d'utilisateur télécharger pdf (Page 38)

PowerPanel™ Business Edition

z Verify that firewall settings. Port 3052(UDP/TCP), port 53568(TCP), port 162(UDP) and port 53566(UDP)

should be unblocked. The Client communicates with the power device on these ports. The installer will

automatically configure Windows firewall to allow PowerPanel

Applications to access through firewall.

The following messages may be displayed:

z Detecting X.X.X.X is unsuccessful. The power device may not be available on the local network

because it is either turned off or the specified IP address is not the one used by this device. Make sure

that the IP address is accurate and the power device is operating then click Retry to initiate outlet

detection again.

The USB cable or serial port between the Agent and the UPS may not be connected or the UPS

RMCARD is installed improperly. Check the cable connections and the installation of the RMCARD and

then click Retry to initiate outlet detection again.

z The device address has changed to X.X.X.X. Client updated using the Auto Configure option. The

IP address of the power device has changed to a new one, and the Client has been configured to match

the new IP Address.

z Network communication can’t be established. Make sure the devices network configuration is

accurate. The Client never establishes the communication with device due to improper network

configuration on the device. See Troubleshooting the Client’s inability to communicate

with the

power device section for more details to resolve this condition.

z Network communication lost. Make sure the devices network configuration is accurate. The

network communication between the Client and the device has been lost. The device could be turned off

and the Client is no longer aware of the condition from the device. See Troubleshooting the Client’s

inability to communicate with the power device section for more details to resolve this condition.

z Can’t fetch the outlet information. Make sure that the device local communication is connected.

The USB cable or serial port between the Agent and the UPS may not be connected or the UPS

RMCARD could be plugged improperly. Verify the local communication is connected property.

z The assigned outlet is in use. Please choose another outlet. Indicates the assigned outlet is in used

by another piece of equipment or computer. In order for the Client to perform a graceful shutdown, it is

recommended to change to another outlet which is not in use.

z The assigned outlet is off. Please choose another outlet. The outlet assigned is not supplying power,

and the wrong outlet may have been identified. Verify the correct outlet is selected. .

z The assigned outlet has a turn off pending. The system will be shutdown soon. The outlet being

used by the Client computer will be switched off and will stop supplying power to the Client computer

after the delay is finished. Save all unsaved files and shut down the hosted computer as soon as

possible.

z System may not shutdown properly because the off-delay is too short. The Client detected the

connected outlet has insufficient time for the hosted computer to perform a shutdown. The off-delay may

be extended in the PDU web interface.

Event Action

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 99 100

Pas de commentaire

CyberPower PDU15SW8RNET Manuel d'utilisateur Page 38