CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 114)

112

 Network communication is untouched Center cannot establish communication with PDU on the network or

established network communication has been interrupted.

 Input is near overload A PDU is near an overload condition. The load level is near the safe load threshold for the

PDU.

 Input is overload A PDU is in an overload condition. The safe load threshold has been exceeded.

 Power consumption is too high Power the specific PDU consumes has been exceeded the high threshold.

 Power consumption is too low Power the specific PDU consumes has been violated the low threshold.

 Shutdown initiated A computer which connects with PDU initiated the shutdown process. The computer will shut

down or enter hibernation.

ATS

 Network communication is untouched Center cannot establish communication with ATS on the network or

established network communication has been interrupted.

 ATS is faulty. UPS has malfunctioned in internal.

 Both input sources are power failure, ATS stays in current one ATS doesn’t switch the source due to both

input sources are power failure.

 Input is near overload An ATS is near an overload condition. The load level is near the safe load threshold for

the ATS.

 Input is overload An ATS is in an overload condition. The safe load threshold has been exceeded.

 Power consumption is too high. Power the specific ATS consumes has been exceeded the high threshold.

 Power consumption is too low. Power the specific ATS consumes has been violated the low threshold.

 Shutdown initiated A computer which connects with ATS initiated the shutdown process. The computer will shut

down or enter hibernation.

Notification Recipient

Please refer to Event Action/Recipient section about how to define notifications,

Settings

Please refer to Event Action/Settings section about how to configure the detail settings of event actions.

Logs

System Logs

The System Logs page in Center provides users logs of recorded details from operations performed in Center. The

logs can be used for analysis or to determine whether operations have been performed correctly.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 132 133

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 114