CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 99)

Power Control

 Power Off: Click Power Off and a confirmation window will appear. Pick the UPS/PDU/ATS from the list and

decide whether to perform an immediate or a sequenced power off. Click OK to begin. When the UPS/PDU/ATS

initiates a sequenced power off, computers with Agent or Client installed will initiate a shutdown prior to the

sequenced power off. An immediate power off will likely cause those lose power.

A confirmation window of a bulk power off operation

 Power On: Click Power On and a popup window appear. Pick the UPS/PDU/ATS from the list and determine

whether to perform an immediate or a sequenced power on. Click OK to begin.

Note: Some computers require manual booting when a UPS or a PDU powers on. To change this, set the

computers BIOS to boot when power is restored.

A confirmation window of a bulk power on operation

 Power Cycle: Click Power Cycle and a popup window appear. Pick the UPS/PDU/ATS from the list and

determine whether to perform an immediate or a sequenced power cycle. Click OK to begin.

1 2 ... 94 95 96 97 98 99 100 101 102 103 104 ... 132 133

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 99