CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 75)

community with write permission, and public with read only permission. The community used by the Client to access

the UPS RMCARD/PDU/ATS must have a minimum of read permission for basic operation. If the community has write

permission, the Client can complete some configuration tasks automatically.

If the Client cannot complete these tasks due to a permission limitation, the following settings must be configured

manually in the UPS RMCARD web or in the PDU web:

Note: The community can be configured on the Network/Access Control (or Network Service/SNMPv1 Service)

page in the UPS remote management card (RMCARD) web or on the Network/SNMP Settings (or Network

Service/SNMPv1 Service) page in the PDU web.

 Outlet Off Delay Setting - Specify the necessary time for the Client to shut down the computer on the

Outlet/Outlet Configuration page in the PDU web.

 Add the IP address of the Client computer to the Trap Receiver list of the UPS RMCARD/PDU/ATS on the

Network/Trap Notification page in the UPS RMCARD web or in the PDU web.

Network/Access Control page in the UPS RMCARD201 web

SNMP Trap Community: The Client uses the community to authenticate the SNMP trap from a secure device. The

community default is public. The IP address of the Client computer must be added to the Trap Receiver list on the

Network/Trap Notification page of the UPS RMCARD and the PDU to ensure the community is matched.

1 2 ... 70 71 72 73 74 75 76 77 78 79 80 ... 132 133

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 75