CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 95)

Computers on Outlets

 Shutdown/Restart: A shutdown or restart can be initiated on a computer with either Agent or Client installed by

going to Shutdown/Restart in Computers on Outlets. A window will list the computers which can be shutdown or

restarted. Clicking “X” will remove that computer from the list and they will not be shutdown/restart.

Note: If a PDU is connected to a UPS, shutting down computers on UPS outlets will result in shutdown computers

in the PDU.

A confirmation window lists computers able to be shutdown

Power Control

 Power Off: Click Power Off and a confirmation window will appear. Decide whether to perform an immediate or a

sequenced power off then click OK to begin. When a UPS or a PDU initiates a sequenced power off, computers

connected to the UPS/PDU/ATS that have Agent or Client installed will initiate shutdown prior to the sequenced

power off.

Note: An immediate power off will likely result in connected computers losing power.

A confirmation window of a PDU power off operation

 Power On: Click Power On to have the UPS/PDU/ATS turn on output power. Decide whether to turn on output

power immediately or after a delay in the confirmation window. Click OK to begin.

Note: Some computers require manual booting when a UPS or a PDU powers on. To change this, set the

computers BIOS to boot when power is restored.

1 2 ... 90 91 92 93 94 95 96 97 98 99 100 ... 132 133

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 95