CyberPower PDU20SW8RNET Manuel d'utilisateur télécharger pdf (Page 52)

 Initiated: Determines whether to execute a command and sets the delay for the command execution. If the event

is cleared within the command execution delay, the command for this event and the corresponding event will not

be executed.

 Duration: Sets the estimated time for the command to complete. If the event requires the computer to shut down,

this delay provides time for commands and scripted actions to complete before the shutdown is initiated.

 File: Sets a command file to be executed when an event occurs. Shell scripts for the command file uses "cmd" as

the filename extension. For more information about shell scripts read the detailed description in the "default.cmd"

file in the "extcmd" folder in the PowerPanel

Business Edition installation directory. Customized shell scripts must

be saved in the "extcmd" folder in the PowerPanel

Business Edition installation directory. The command file will

be listed on the Command/File list and can be executed when the power event occurs.

Note: The command file name will be displayed in italics if the command file which had used cannot be found in

the “extcmd” folder.

The following environment variables can be placed to external commands to identify which event and which stage to

be executed.

 %EVENT_STAGE%: Indicates what stage of firing event to execute the commands. When an event occurred and

enters OCCUR stage, the assigned commands will be executed. When an event is ended, the variable will be

FINISH and the assigned commands will be executed.

 %EVENT%: Indicates which event is fired to execute the commands.

 %EVENT_CONDITION%: Indicates which the detailed event condition of a firing event.

 %MODULE_NO%: Indicates which UPS module on a firing event. This variable is used on Modular UPS models.

Users can know how to configure commands from the following table which lists all details of %EVENT% and

%EVENT_CONDITION%.

%EVENT%

%EVENT_CONDITION%

Event Name

BATTERY_CRITICAL_LOW

Battery capacity is critically

low.

ENTER_BYPASS

Enters bypass mode.

BATTERY_EXHAUSTED

The battery has been

exhausted.

EMERGENCY_OFF

EPO is active.

BATTERY_FULL

Battery is fully charged.

SHUTDOWN

Shutdown initiated.

BYPASS_FAILURE

Bypass power is failure.

CAPACITY_INSUFFICIENT

Inverter capacity is insufficient.

LOSS_REDUNDANT

Power redundancy is not

enough.

ABNORMAL

UPS is abnormal.

NO_NEUTRAL

Input is no neutral.

WIRING_FAULT

Site wiring fault.

FATAL_ABNORMAL

UPS is fatal abnormal.

OUTPUT_OVERLOAD

Output is overloaded.

BYPASS_OVERLOAD

Bypass is overloaded.

MODULE_OVERLOAD

Module is overloaded.

SHORT_CIRCUIT

Output circuit-short.

MODULE_RECTIFIER_OVERHEAT

Module rectifier is overheated.

MODULE_INVERTER_OVERHEAT

Module inverter is overheated.

MODULE_INVERTER_PROTECTED

Module inverter is protected.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 132 133

Commentaires sur ces manuels

Pas de commentaire

CyberPower PDU20SW8RNET Manuel d'utilisateur Page 52

Commentaires sur ces manuels

Produits connexes et manuels pour Unités de distribution d'électricité (PDU) CyberPower PDU20SW8RNET